Primos trigger stick bi pod modifications

I have the Primos tripod. While I was sitting the next room it failed and dropped my Impact to the floor on two occasions. So, I set a ten pound weight on it and it did the same less than than ten minutes later. So, I no longer buy anything that is associated with them and my tripod is relegated to only holding my lightweight chronograph.

Yea further support the best of the PRIMOS trigger sticks were the Gen 1's ... damn shame they quit making them & no clue why they stopped ?

This is what I came up with and it works good. Please notice that there are 2 drill bits still in there. Also pay attention that the mechanism to allow the sticks to go up and down is inside there as well. I would look at putting the screws or maybe something else in the plastic above instead of in the mechanism. 

This is what I came up with and it works good. Please notice that there are 2 drill bits still in there. Also pay attention that the mechanism to allow the sticks to go up and down is inside there as well. I would look at putting the screws or maybe something else in the plastic above instead of in the mechanism. 

Click to expand...

Looks like a decent mod …. I did mine last wk to limit leg spread. I also glued the handle base to prevent swiveling because I don’t need it. We will see if its worth using after awhile … I couldnt get used to it the way it came, even with a cord limiting travel, since that still allowed the handle to rock from side to side too much.