PCP rifles with an externally adjustable regulator

New Wildcat.

Wicked Air Rifles FLEX Cobra and WARP Cobra

JSAR Raptor (not yet available)

Oh mass produced...not sure these qualify 

The 30 caliber for sure. I've also read from others with smaller calibers that they have an AMP reg.

Nova liberty is 'externally adjustable' but requires degas I believe. Any FX with the 'AMP' offering should be as well.



I think the externally adjustable regulator feature will be implemented in many future pcp releases as its quite simple to design/engineer and integrate into existing platforms.



-Matt

Zbroia Sapsan will have the ability to adjust up or down, I think you will have to remove the butt stock

and you can change calibers........ I do not have a release date yet, it has been seen at gun shows by Joe the bottle guy

https://zbroia.ua/en/produktsiia-kompanii-zbroia/pnevmaticheskie-vintovki/sapsan

The Huben K1 does, I believe, as do the Brocock HR and HP (Magnum) versions of the Sniper and Commander.

Does anyone have idea about Zbroia sapsan Gen I regulator adjustment tuning?

I would like to tune my regulator.but if I tune it for 18.13 grain pellet i got 840 fps only.i want to increase 900 FPS What shall i do?

I have no experience with that reg, but in general, your reg set point and hammer spring tension need to be in reasonable balance. If that is your maximum velocity at full spring tension, and an increase in reg setting doesn't result in an increase in velocity, then that's probably all you can get with the current internal parts.

Leshiy 2 REPR

What? No one mentioned the Air Venture Avenger yet?

Reximex Throne and the coming soon Benjamin Gunnar is supposed to have externally adjustable regulators. 

Brocock Bantam HR 

Brocock Bantam XR 

Usually in every air rifle after every shot the regulator pressure will set back to the regulator pressure bar tuned in it in a fraction of second. But in zboria sapsan it takes around 20 secs to get back to 150 bar pressure which I have set. So I cannot fire immediately. Does anyone faced this issue. If so tell me how to rectify it.

RTI Prophet has adjustable regulator, but I haven't seen any instructions on degassing. If anyone knows if degassing is required for adjustment please let us know.

If you lower the reg pressure on the prophet you can do it by dry firing 3 or 4 times for every 1/4 turn of the adjusting screw. This is directly from the manual. My gun also has the option to empty the gun completely with the bleed valve in the butt stock. Then back the reg off, refill and bring the pressure up to where I want.

zbroia sapsan 1 st generation. The barrel here is floating barrel so there is mild wobbling which in turn results in inaccuracy. If it is so it will get loosen in further usage. Does anyone faced this issue. How to solve this problem.
Anyone share with me the way to set it in a fixed position.