I just ordered a o-ring kit from AOA for my regulated Fx bobcat mk1. Does anybody have input on do's or don't before I get started. This is my first time taking the gun apart. With the kit I also had AOA add in silicone grease per there recommendation to lube the rings on install.
If I use a micrometer to measure the regulator length before disassembly and noting length. On reassembly can I set the length the same and have equal regulated pressure as before?
Is there a adjustment for the hammer bounce spring?
Will I need to locate/note it's setting before disassembly?
I was expecting to measure the depth of the hammer bounce Allen headed nut in reference to the housing, or maybe there is a better way? I often over think these kind of things.
Thank You
If I use a micrometer to measure the regulator length before disassembly and noting length. On reassembly can I set the length the same and have equal regulated pressure as before?
Is there a adjustment for the hammer bounce spring?
Will I need to locate/note it's setting before disassembly?
I was expecting to measure the depth of the hammer bounce Allen headed nut in reference to the housing, or maybe there is a better way? I often over think these kind of things.
Thank You