Can someone point me in the right direction for a schematic for the Evanix Rainstorm II .30 cal? I thought I had located one a few weeks ago and bookmarked but I guess that I just imagined that I did. I'm getting ready to install a Huma reg in it and would like to be familiar with the internals before I tear into it. Thanks in advance.
need schematic for Evanix RS II
- Thread starter Badgerfarm
- Start date
I installed a huma reg in my Rainstorm II .25 cal last night. It's not bad. I used the instructions provided. The instructions aren't for the rainstorm II, but it's similar enough I didn't have a problem.
Evanix Rainstorm II schematic
To make the image larger, right click on it and select "Open image in new tab"
Evanix Rainstorm II schematic
To make the image larger, right click on it and select "Open image in new tab"
Upvote 0
The more I look at the schematic in my previous post, it looks like there are subtle differences. That might be a Rainstorm and not a Rainstorm II
The only other thing that I could find is for the Evanix Blizzard S10. This looks more like the Rainstorm II. Same cocking and hammer mechanism, same valve block and tube setup. Screws look like they're in the same locations.
The only other thing that I could find is for the Evanix Blizzard S10. This looks more like the Rainstorm II. Same cocking and hammer mechanism, same valve block and tube setup. Screws look like they're in the same locations.
Upvote 0
Could you post a shot string with the Huma regulator installed on your RS II?"Rich7777"I installed a huma reg in my Rainstorm II .25 cal last night. It's not bad. I used the instructions provided. The instructions aren't for the rainstorm II, but it's similar enough I didn't have a problem.
Evanix Rainstorm II schematic
To make the image larger, right click on it and select "Open image in new tab"
Upvote 0
I'll be at the range this weekend. I can share my results next week. I don't anticipate the efficiency to be where I want it. Now that the reg is in, I need to work on the hammer spring. The factory spring will have to be modified or replaced with a lighter spring. The hammer spring tension (HST) screw on the rainstorm II has a small amount of adjustability. It looks like it was designed for micro adjustments.
If you're interested, there is a huge thread on the Rainstorm II over on GTA. Knifemaker has been working on getting his dialed in. The thread is "Rainstorm II arrived!". It's 38 pages long, but there's some hidden gems in the thread if you're willing to read through it.
Upvote 0
I'm aware of that thread on the other site but I couldn't keep up. I'll wait till you're done. No rush lol.
Upvote 0