need FX Royale reg adjustment help....

mubhaur · Jun 11, 2016

In 5 to 10 seconds the regulator doesn't recover fully hence the hammer spring opens the valve much more that increases fps. In more delay the regulator recovers better and under greater pressure hammer opens the valve a bit less.

It is as it is unless you get a specialised regulator with 3 to 5 seconds recovery time

sniperlabyo · Jun 11, 2016

"mubhaur"Dear Ernest,

I did the same with my fx royale regulator. I disassembled it. Glass polished the ends of Bavilier washers. Applied thin coating of semi liquid moly grease. But my piston is not that freely moves when I push it. I throughly greased the O rings of the pistons. Reassembled the piston. Pushed and pulled it. It appeared better. Then installed Bavilier washers. Set the reg at 140 bars. After each shot it comes back to 140 but then creeps to 145 bars. The recovery time was not good initially but it is improving now.

I assume that after the complete service of regulator it might take a few hundred shots to settle properly.

It recovers to 140 bars in 20 seconds and reaches 145 in 5 to 10 minutes.

Please extend further suggestions if any.

Regards,

Umair Bhaur

Something not right , I shoot as fast as the crony can read out the speed I get tight ES even waiting 15min or so.

i would back out the brass till the piston travel 1-2mm

PlanB · Jun 11, 2016

Thanks Earnest, by specialized do you mean another reg or fix the royale reg?

PlanB · Jun 12, 2016

trying a chrono pic of 22 royalehttp://[URL=http://s261.photobucket.com/user/tcole111/media/viewsat/450A4E17-6703-4164-AC17-3629180869EE.png.html]

[/url]

Search

Search

need FX Royale reg adjustment help....

mubhaur

Member

sniperlabyo

Member

PlanB

Member

PlanB

Member