This morning, after the rubber glove advise applied, I found out that leak is from the gauge.
Just hoping it's the oring behind it...
Fingers crossed.
Just hoping it's the oring behind it...
Fingers crossed.
Upvote 0
My brand new Leshiy has a (slow) leak
- Thread starter barreira
- Start date
After I empty/bleed the deposit do I need to unscrew the deposit from the action to unscrew the filll plug and gauge, or I can unscrew the fill plug and gauge with unscrewing the deposit?
Upvote 0
So you need to put the glove/balloon over just the face of the gauge first. This will tell you if the o-ring inside the EDMU is leaking. If the balloon/glove doesn't react then slide it down further to capture the whole gauge (including part of the air reservoir). This procedure will diagnose which o-ring is leaking
Brian
Brian
Upvote 0
First atempt I slide it until the reservoir and there's a leak for sure... 
This night I will try just in the gauge.
This night I will try just in the gauge.
Upvote 0
A little soapy water will show tiny bubbles around the bezel between the lens and metal only takes a drop or two other wise its between the gauge and gun.
Upvote 0
Hey Brian, did you notice my other post about the air tube you said you'd order for me? I got a couple fx rifles in the mean time I can shoot but would sure like to shoot my leshiy with than nice dedal scope I bought from you.
Upvote 0
You need. 3X1. Here's the thing about O-rings, I have seen them last 1 month to 5 years, it is rubber after all. You'll need to contact your local dealer and have the o-ring replaced to open the gauge requires a special tool
Upvote 0
I posted this link over on the FP Group, but here it is again, he shows you how to get your EDMU out, go from there to the O-ring.
https://youtu.be/iyzomZEZHgI
https://youtu.be/iyzomZEZHgI
Upvote 0
Mine leaks. cleaned/lubed, still a tiny leak...,. no worries. Handpumping means I can skip doing my pushups and it only takes 3 or 4 minutes with a China-Pump. I love the electronic gauge but may swap out at some point.
Still loving the Leshiy!
Still loving the Leshiy!
Upvote 0
Check the o-ring under the gauge. It's in a recessed area and hard to get out, but once I replaced it mine has not leaked at all. I love mine too!
Maybe I should clarify, mine has the OEM analog gauge. I assume there's no difference with the o-ring under it or the EDMU.
Upvote 0
I'm waiting for a new EDMU to arrive. If leak remain I will change it to a WIKA guage...case closed.
Upvote 0