Max out elevation

Yes I did notice the liner was twisted a little bit I thought that it was loose so I twisted it until it was tight and went to tighten the 2 screws and they where tight ! I had a barrel band on it at first and I accidentally hit the barrel when bringing the gun inside Sunday before that I even had installed Picatinny spacers because I couldn’t adjust my scope it was touching the rail but before all of that it was tack driving every time I shot it! So I will but my Tactacam on and put my laser bora sight in and rotate the barrel and see what I get it’s going to be hard by my self so hopefully with the Tactacam I can look at my phone and make adjustments! Thanks guys I was about to buy another scope and rings!! Now I can buy pellets now !! 

So i fixed my problems! First I had to re- zero my scope crosshairs to center witch they where way off by using this Mirror method that I found here https://youtu.be/SvgOKMX9Gvg and then re-zero my Turrets back to zero so the scope was back to factory zero!! 


then I installed the scope back on the gun got out my laser boresight install it and Tactacam back on scope set up a Poi in my living room looked on my phone threw the Tactacam and saw where I was off by touching the shroud it moves a lot so I put back on the barrel band and it lined everything up don’t asked me how but it’s dead on now cinched everything down and went to my bench to shoot at 50 yards and this is the result!! ! Top row was the fine tune on the scope and every other target was one shot the middle one was my dog hitting the table leg as I shot! Not bad ! Thanks for all the tips guys! It was looking expensive there for a while .so when in doubt take a step back and process what’s going on and take your time from step one