Hey guys new here. Just ordered an FX Impact with lots of aftermarket goodies! I would like to see how you have your impact set up and how you like your mods.
Thanks!
Thanks!
Let's see your FX Impacts!
- Thread starter Jakeonthekob
- Start date
I'm in too.
As it is today lots of mods have gone into it.
First was an Aztec scope then a .25 700mm barrel then slug barrel.
Then I did a DIY rear mono-pod to make things a bit more stable for long ranges.
After that I opened up the barrel and probe ports, cut the valve spring and added a small brass hammer weight/washer.
Got hold of another valve body, that was ported slightly, and installed my drilled out 6.1mm valve seat in it.
With more power I wanted more shots so picked up a 580cc tank.
A Kraford and Lypt extended trigger guard let me put the bipod out front and made things more stable.
Then on to bigger and better things one of Michal's plenums.
Once that was installed I spent lots of time tuning. Ended up at 960fps with the NSA 36.2 slugs to make it MOA at 100 yards often 1/2 MOA when the wind is low and I plink spray paint cans at 200 yards.
Recently about 1000 rounds back I installed a lightweight Gladius moderator it takes care of the high end bite a little better than the stock units. It has been great for me but others have had some troubles.
I can actually say that everything I have done has made the gun shoot better for me. I have had it up over 80fpe it will probly go higher but it shoots lights out at 960fps and 74fpe so I leave it.
https://www.airgunnation.com/topic/ups-brought-me-a-polish-plenum-today-2/
https://www.airgunnation.com/topic/another-mod-for-the-fx-impact/
As it is today lots of mods have gone into it.
First was an Aztec scope then a .25 700mm barrel then slug barrel.
Then I did a DIY rear mono-pod to make things a bit more stable for long ranges.
After that I opened up the barrel and probe ports, cut the valve spring and added a small brass hammer weight/washer.
Got hold of another valve body, that was ported slightly, and installed my drilled out 6.1mm valve seat in it.
With more power I wanted more shots so picked up a 580cc tank.
A Kraford and Lypt extended trigger guard let me put the bipod out front and made things more stable.
Then on to bigger and better things one of Michal's plenums.
Once that was installed I spent lots of time tuning. Ended up at 960fps with the NSA 36.2 slugs to make it MOA at 100 yards often 1/2 MOA when the wind is low and I plink spray paint cans at 200 yards.
Recently about 1000 rounds back I installed a lightweight Gladius moderator it takes care of the high end bite a little better than the stock units. It has been great for me but others have had some troubles.
I can actually say that everything I have done has made the gun shoot better for me. I have had it up over 80fpe it will probly go higher but it shoots lights out at 960fps and 74fpe so I leave it.
https://www.airgunnation.com/topic/ups-brought-me-a-polish-plenum-today-2/
https://www.airgunnation.com/topic/another-mod-for-the-fx-impact/
Upvote 0
Upvote 0
Upvote 0
