The butt stock is Mil Spec
https://www.airgunnation.com/topic/edgun-leshiy-full-review-after-5-months-5k-p
Upvote 0
Let's see those Leshiy's!
- Thread starter Tweeter
- Start date
The butt stock is Mil Spec
https://www.airgunnation.com/topic/edgun-leshiy-full-review-after-5-months-5k-p
This is why I opted for the DonnyFL adapter, with the Sumo LDC. I'm able to remove the LDC and pack the gun then install the LDC when I'm ready to hunt.
Upvote 0
Thanks Here is mine. Brian hooked me up with the sand-colored extended barrel kit in .25 caliber. I am getting 18 shots per fill at 810 fps with the Huma set at 108 and 10 clicks on the hammer spring when filled to 250 bar. You can go higher, but I like this balance of shot count and velocity and the accuracy is great. Has the two-stage trigger mod. Evolution bipod is off my Impact. These special edition guns are all metal and amazingly well made like all the Leshiy's.
Upvote 0
Nice! Out of all the colored leshiys that is my favorite. I wish I would have known these would be available when I bought mine a few months ago, I might have waited.
Upvote 0
You might consider buying one and selling your other one? From my Emails with Ed he said they don't have plans to make colors any more because it's too expensive?
Upvote 0
Upvote 0
Nice Drew. I like hearing... all stock. Same with mine. I kept mine stock as well. No added length for me makes for a nice compact setup. And The original reg works fine for me as well. Im honestly somewhat worried about going to a huma after seeing posts about valve issues once the reg is changed. No thanks. Mine works just fine. I will admit that the increased shot count would be nice but with the potential of a failure. Ill pass.
Upvote 0
This is the first I have heard of any valve issues can you explain? How would a different reg cause any issue that the stock reg isn't if they are both doing the same thing? Unless it is because some use a set pressure that requires a lot more hammer spring tension and it ends up breaking the valve stem?
Upvote 0
Same here, I haven’t heard of any valve issue with the Huma regulator. My understanding is with the Huma you are using lower reg pressure and larger volume of regulated air due to having a larger plenum. This is how it’s pushing the pellet faster with lower air pressure. Shouldn’t it make the value last longer?
Upvote 0
I think i remember the issue being with the 12fpe Huma kit. Too much hammer spring in stick form. Basically need to cut it back.
Upvote 0
I have the 12fpe kit, it comes with the plenum reducer insert and a weaker hammer spring. Absolutely no issues! The shot count is insane considering I have the additional air tube.
the first gen Leshiy's had issues with the valve and the hammer because of the hammer's shape. But that has since been corrected in the gen 2.
Upvote 0
EXACTLY - they ORIGINALLY did not come with the weaker hammer spring, thus the broken valves if you didn't cut your original hammer spring.
The 1st gen issue with the hammer was to vent it so it did not seal in the tube and slow itself down.
Upvote 0
Ok that makes sense. Nothing to worry about with the regular Huma then.
Airgunnerca, sweet leshiy!
Airgunnerca, sweet leshiy!
Upvote 0
That John Hagan piggyback air tube is crazy nice! Can you give me an idea what it cost???
Heres Leshiy with a bigger Optisan EVX 4-16x FFP scope and John Hagan air cylinder. I shot a field target match with this set up and did pretty well.
Upvote 0