Large Impact Regulator gauge

If you’re talking about short tube between the rear block and the reg pressure gauge that’s an add on plenum I believe Ernest is developing as a high pressure/performance kit for the Impacts shooting slugs around 900+fps. 

It's not for sale from FX right now but you can make your own (20cc) from a 300 bar inline filter. The one pictured is from a Yong Heng compressor. You also need a M10 to 1/8 BSP adapter drilled to 6mm and the valve housing must be modified. The bottom gauge is sealed with a dowty/bonded seal washer. It helps to have a larger valve seat that is also not for sale right now from FX. The easiest thing to do is ship your gun to Ernest Rowe at FX USA to have it power tuned. He gets big power increases along with efficiency. You can call them at 1-866-639-0772

Here's a picture of the high power kit that is not for sale right now from Ernest Rowe/FX USA.

HP kits will be out eventually.. I’m patiently waiting to see when they do. 

Matt

Is that long thing the valve stem? Can't imagine what else it could be with how it looks but it's massive

Is that long thing the valve stem? Can't imagine what else it could be with how it looks but it's massive

Click to expand...

Valve rod... it's a bullpup.

Is that long thing the valve stem? Can't imagine what else it could be with how it looks but it's massive

Click to expand...

Valve rod... it's a bullpup.

Click to expand...

So it is thanks for letting me know. And I've had 2 bullpups, Taipan Veteran and Edgun R5M and both valve stems/rods were short so must be an impact specific thing but cool to see.

So it is thanks for letting me know. And I've had 2 bullpups, Taipan Veteran and Edgun R5M and both valve stems/rods were short so must be an impact specific thing but cool to see.

Click to expand...

The trigger mechanism is forward on an Impact where other bullpups use a long rod for their trigger mechanism at the rear.