I have a gen II high pressure reg in my .25 Crown. I blew the reg valve housing O-ring so replaced all three. It won't stop leaking out the vent even after changing them again (not the internal one its a pain!) suggestions??
Dennis
Dennis
HUMA REG
- Thread starter 2D1C
- Start date
Vent leak ...
If either o-ring on the spool is damaged you have a leak out vent via going into were bevel are at.
If either o-ring that seals the regs body to the I.D. bore it sits within you have a leak out vent via around the valve body.
What it is ....
Scott S
If either o-ring on the spool is damaged you have a leak out vent via going into were bevel are at.
If either o-ring that seals the regs body to the I.D. bore it sits within you have a leak out vent via around the valve body.
What it is ....
Scott S
Upvote 0
I'm wondering if the spool is damaged I have another piston I could use to see if it stops. I also request the o-ring sizes to see if I used the right ones. I appreciate hearing back from you Scott
Upvote 0
Spool being DAMAGED not likely ... other than end to end compressive load the spool is just a dynamic part.
If one were to use a sharp pick in taking out the o-rings and made a healthy scratch on the side & root of o-rings groove it could be damaged tho.
If one were to use a sharp pick in taking out the o-rings and made a healthy scratch on the side & root of o-rings groove it could be damaged tho.
Upvote 0
Well it appears there is an Oring inside the receiver # D29 which is 9x1.5 NBR 90. I thought I had EVERY oring for this gun but not that one! Funny Earnest never mentions that tidbit! I'll confirm tomorrow and order accordingly.
Thanx Scott
Thanx Scott
Upvote 0