Huma inline regulator problem

dallin · Mar 15, 2019

I put a pressuregauge on my airtank this morning.

when I was about to bleed the hose. It bled for 2 seconds and then it stopped instantly. Sounded like something blocked the bleeding hole.

the pressure gauge indicates that there is about 230bar on the filling line.

So my question is how do I bleed the pressure?

anyone who has experienced the same?

hope for a quick answer

thank you

1552647913_6174480925c8b86e9a00d54.87223921_FB50410D-EADF-480A-ADB7-F0C0ABC132AA.jpeg

sonny · Mar 15, 2019

might gently slowly open a connection/fitting

Spray1Mark · Mar 15, 2019

Has it stopped at the regulator set pressure? can you still rotate the regulator body?

dallin · Mar 15, 2019

I can rotate the regulator but not at easily as when not pressurized.

anyway problem solved

knife + hose = hose with a hole in it haha

Spray1Mark · Mar 15, 2019

Do you have an endless supply of hoses? or have you actually worked out what went wrong?

willy · Mar 15, 2019

Turn the brass bleed vale on the bottom lower right hand corner counter clock wise slowly,then back out the gauge a little.

dallin · Mar 15, 2019

I can make the hose at my workplace

and no I didn’t find out anything.

when I pressurized it again it worked fine.

don’t know what happened

Search

Search

Huma inline regulator problem

dallin

Member

sonny

Member

Spray1Mark

Member

dallin

Member

Spray1Mark

Member

willy

Member

dallin

Member