Solved - Huggett shroud for Daystate 22 grub screw size

DellaDog · May 5, 2017

Recently purchased a Huggett shroud and LDC for the Daystate AirWolf .22
Problem is it's missing two of the three set screws and I have no idea where to find them.

They appear to be 3/16 wide by 5/32 long or so.

Anyone have any idea exactly what screws to use and better still where to find them?

Thanks

ACE is the place - M5 x .80 pitch.

John "spysir" Blount · May 5, 2017

Not sure where you are located but as you so have one screw, I always use Ace Hardware first try, try have thread gauges and a pretty good fastener section most places.
Or, for maybe $5.00 @ but they WILL have the correct screw try " Fastenal " they WILL have what you need.

John

DellaDog · May 5, 2017

Thanks John, actually my plan was to head to ACE hardware tomorrow with the remaining screw and see if I can find a match.
Plan B, Fastenal.

Keith2324 · May 5, 2017

I'm not sure if they are they same size as the screws on the original Daystate shroud, but I emailed Daystate a while back and they said the size is SKT SET M4 x 4. I hope this helps.
Keith.

DellaDog · May 5, 2017

Thanks Keith, unfortunately they're just a tad larger than the Daystate originals. That was my first try.

DellaDog · May 6, 2017

ACE is the place – M5 x .80 pitch.

John "spysir" Blount · May 6, 2017

Thanks for the update, likely help folks down the road.
John

Search

Search

Solved - Huggett shroud for Daystate 22 grub screw size

DellaDog

Member

John "spysir" Blount

Member

DellaDog

Member

Keith2324

Member

DellaDog

Member

DellaDog

Member

John "spysir" Blount

Member