Hatsan Bully .30 with the DonnyFL Emperor, shooting video added.
- Thread starter Imold
- Start date
Sup guys so I had ronin on my bully.30 but it wasn’t quite enough for me so I brought the emperor knw my accuracy is every where put the ronin back on it shootin lights out... what y’all thinks going on...
Upvote 0
I brought the emperor for my bully.30cal want hold accuracy and mines emperor is 357 n up....it’s clipping
Upvote 0
hello.you wrote a long time ago.question.hatsan bully 30. I can't unscrew the thread on the tube for the sound moderator.help..can it be unscrewed or?
Upvote 0
I believe I used the DonnyFL A35 adaptor on mine so unless they changed the end on the bully it should be threaded, sometimes the end cap can be hard to remove.
Upvote 0
Friend help.whether it helps how much the moderator emperor.how much he reduces the shot.on the scale from 0 to 100.
Upvote 0
I’d say 80+%, I have a video up of me shooting it with LDC on. It the very 1st post..The .30 hitting the metal target is just as loud.
Upvote 0
Video great.which adapter do i need to connect H bully 30 cal with donifl emperor 1/2 or 18/1 or both fit
Upvote 0
I dont know why Hatsan made the QE like this. They made silencers before.
You dont need a additional silencer, only some adjustments.
Open barrel front , take out the 2 mesh tubes , cut mesh tubes in half and sand the ends. Look for washers 22mm wide , i used washers tar inside for rooftops ,drill holes to 8,5mm. Reassemble the mesh tubes and each time put a washer in between screw end on and finished.
You dont need a additional silencer, only some adjustments.
Open barrel front , take out the 2 mesh tubes , cut mesh tubes in half and sand the ends. Look for washers 22mm wide , i used washers tar inside for rooftops ,drill holes to 8,5mm. Reassemble the mesh tubes and each time put a washer in between screw end on and finished.
Upvote 0
Can you sketch out your description? Then post it? I’ve read your reply like five times and do not understand the description of “washers tar inside for rooftops”
Upvote 0
What helped with the rapport on my Bully while using a Shogun, was to remove the felt wrap around the shoguns inner core baffle system, and replace it with neoprene wrap cut out from an overly stretched out mid section abdomen body wrap. Truly made the Shogun worthy of a Bully 30 cal. I say that because at one time when the hercules Bully came out, DonnyFL’s website under the Shogun said in fine print not for the hatsan herc bully.
Upvote 0
You can use whatever washer fits , found these with 22mm width and sand them until fit 21,7mm. With belt sander , put drill in hole and let it roll on belt sander.
Upvote 0
You can use whatever washer fits , found these with 22mm width and sand them until fit 21,7mm. With belt sander , put drill in hole and let it roll on belt sander.
Great, thank you! Everything makes sense now.
so how much better did this help in quieting down the rapport?
Upvote 0