Gauntlet Schematic

Link will not work for me.

I have the PDF but can not convert it. PM me an email and I think I can attach it. Or Umarex will send it to you.

John

edit
they do not list orings sizes. Just carry it on into acehareware or such a find something that fits.

I replaced all 3 with the same o-ring. It works as it should.

How about just putting the pdf in the body of your message. The link doesn’t work. 

Do you know if one can buy the barrel band of the Gauntlet 25 separately and install it on a Gauntlet 22 ???

Do you know if one can buy the barrel band of the Gauntlet 25 separately and install it on a Gauntlet 22 ???

Click to expand...

At one time you could but so many people were installing them incorrectly and essentially voiding the warranty on the PCP Umarex service says you have to send the gun in for the part to be installed.

Umarex told me same thing Hajimoto posted. Hajimoto, is it really that hard to install the new barrel band?

 Gauntlet_schematic.pdf

Just thought I'd put a more recent schematic here with the .25 parts in case anyone is looking for it.

Umarex told me same thing Hajimoto posted. Hajimoto, is it really that hard to install the new barrel band?

Click to expand...

@Jonah that is a really subjective question. I say not really but for someone that does not work with aluminum or understands basic machining and fabrication/assembly techniques, I could see where it could go off the rails. Because there are no existing fastener holes that can be used to install the part, that means the support needs to be aligned and marked properly not to mention the drilling of the two holes required which need to be at the appropriate angle to allow fasteners to be run in which essentially are cutting their own threads.

Hajimoto,

Interesting and informative response to my question. I wondered what was required to install the new barrel band.

Sounds like to me it would be a good video on the installation. All of your videos on the Gauntlet have been very good. I know many air gunners would have some problems with the precise work required to install the barrel band. But even if someone does not want to tackle the project, just seeing what must be done by someone such as yourself would still be interesting. 

Buenas yo soy de cuba y tengo un gauntlet cal .177 pk es el único calibre permitido. Por la poca potencia en este calibre cambie la valvula de 1100 a una 2200 y el depósito a 4500psi y se me ha hecho imposible lograr que sea preciso esto rifle. Alguna sugerencia o explicación del porqué suceda esto?

Gauntlet .25 schematic?

I see schnottus may have had a link to this schematic in a post above but I didn't see a way to get it. Can anyone provide one?

Gauntlet .25 schematic?

I see schnottus may have had a link to this schematic in a post above but I didn't see a way to get it. Can anyone provide one?

Click to expand...

I just tried it on an old windows lap top, took a few seconds but loaded fine.

Cant upload a pdf here.

Maybe



Good luck reading that,lol.

Mayve just try the op link again?

John

Thanks for the help.

The fill port o-ring had started leaking. I cheated and was able to fix with harbor freight oring. I believe it was 3X1mm.