FX Streamline Shroud Removal

Checked youtube ??

It screws off with the air stripper, I can’t remember if it’s right or left handed.

Use a micro torch to heat up the threaded tip of the air stripper until the heat transfers down the air stripper to where it is threaded on the barrel. (the factory uses Loctite on the barrel threads). Once it is good and hot and the Loctite begins to smoke wrap a piece of leather around the threads of the air stripper, and using a pair of Vise-grips or Channel Locks screw it off counter clockwise. Then you may easily pull the tube off the barrel - it has an o-ring at the breech end of it that fits snugly, but it is not threaded at the breech end. Do not use Loctite when you put the air stripper back on because you will want to take it off whenever you clean your barrel, otherwise you may get a patch caught up in it.
Best regards, Chuck

I have called fx USA, Utah air guns and a local buddy. I cannot remove the barrel off of my streamline. It has a fx hyrid slub in it about 2 inches from the end of the barrel. Can anyone help?

Mine will unthread with ease. It is right hand threaded so counter clock wise. I would not apply any heat. Just get someone to hold the rifle and grip it with rubber gloves and it should unscrew if is that tight.