Fx Regulator Tester, where to get from?

Not in the US but they ship fast....................https://www.huma-air.com/Huma-regulator-tester

Any digital pressure gauge 200 to 300 bar pressure, and bsp 1/8 tread will do, most are 1/4 bsp, so you might need a connector 1/4 to 1/8 bsp

For example Search for "digital pressure gauge 250 bar" on google images or ebay, aliexpress..etc

You need to take out the stock gauge regulator, and put the electronic one (is very common use on tuners/airgunsmith) check it and then if you like leave it there (bulky) or put the stock reg back.

I your gun a stock regulator >>???? if so send it to Ernest in FX to adjust or if you want to try , buy an extra gage

then remove stock you will see a brass screw to bleed air remove it and install a gage there and refill it and see the reading ay for example

120 bar and you want to try 130 bar then drain remove tube , mart nut on reg body and move a tiny bit clockwist to raise pressure or oosten to lower it , like 1/16 OF A TURN ONLY REINSTALL AND REFILL gun and see what gage reads ,thi is only way with out buying a reg tester and making some specual bushings to adaptor..it may be time consuming , and use alot of air ,as you have to remove tube each time good luck ,

I have to stress if you turn too much it will take you many attempts to get back , turn very very slightly 

Contact aerotulz@gmail,com he'll make you one.



Zonk

Sorry, the 1/8 bsp is for the impact, donno the tread that the bobcat or wildcat have

id like to buy leshiy reg tester