So, I have two of these FX Ranchero`s on order. .177 and .22. But I am not a very big synthetic stock fan, and I also would prefer some changes to the stock. (Add some finger grips, extend the fore end, give a slimmer look all over, some chiselling around the back grip- and so on).
I made a sketch, and contacted Steve Corcoran at Woods and Water Outdoors (one of the sponsors here on AGN), and asked something like:
- "Based on this drawing, can you make me two pistol stocks. It has to be good wood, and as a couple they have to come from the same blank so to say".
I got a positive respond right away, and after some e-mailing where I picked the preferred wood, he now can present me the master.
The final results based on the master is yet to come, but in the mean time I would like to share this with you.
By the way. The wood between the two pistol profiles has potential for a knife shaft. I have asked Steve to consider this when cutting, and let me have this piece.
A pair and a knife from the same wood....... I think that will be awesome!