FX no limit scope rings
- Thread starter gto19
- Start date
I think Ted has a short video how he does it, same way I did/ do mine, put Airgun on a solid rest, zero in at 50 yards then take a shot at 100 yards and see where the pellet hits, then loosen up the front and back of the no limit rings, and while looking through the scope lift the back of your scope up till your crosshairs are centered where the pellet hit, tighten rings down and shoot the 100 yard target again, repeat if necessary or if your close enough you can just adjust the crosshairs. You can keep doing this out to 200-400 yards if you have enough adjustments with scope and rings.
Its pretty easy...If you want you can make small marks on the rear ring body so you have a idea where to move to if you put rings back to stock setting or height.
had to change can’t to can...didn’t realize auto correct changed it.
Its pretty easy...If you want you can make small marks on the rear ring body so you have a idea where to move to if you put rings back to stock setting or height.
had to change can’t to can...didn’t realize auto correct changed it.
Upvote 0
Should add if you can zero out your elevation and windage when you get your 50 yard zero done it helps but not all scopes have the zero turret option.
Upvote 0
I got these rings for the exact same reason (quick readjusting at long ranges), for my Bobcat .25, but they intimated that the barrel was way low and off to the left. So much so that bringing them back on line, pushed the scope erector tube to it’s fullest extent. I spent long hours reversing the rings from right/left forwards/backwards , which made small gains, just not enough. (Maybe I just got a badly machined set), so I binned them in preference for SportsMatch ATP66 fully adjustable which indicated that the FX barrel did not deviate off to the left etc. These also do the “Long Range” trick nicely too.
Upvote 0
The way I did it is I took an approximately 4’x8’ piece of a large cardboard box side from an appliance store garbage pile. Set it up at 100 yards with a 4” bullseye on it mounted my scope with the rings on rifle and made sure the the cross hairs were not jacked up or down , it was 4 turns from top to bottom so I set it at 1.5 turns from bottom to start, so I wouldn’t have to worry about having enough up left in the knob when doing fine adjusting. Slightly loosened both mount then raised rear mount about 80% up the tightened both with front at lowest. Then I looked through scope and shot cardboard aiming at 4” circle I was high by a foot or so, so I raised rear mount by another 10% to 90% up then I was right on height wise for 100 yards did som fine adjustments with knobs, I then moved target to 50 yards to see how many dots below cross hairs would be my 50 ‘ aim point then the same at 150 and 200 to see how many dots to see how many dots above cross hairs would be aim point at those distances.
Upvote 0
Upvote 0
The purpose of the no limit rings it to allow you hit a distant target that’s centered in the crosshairs do to the relatively short range of air pellets (lead shuttlecocks) you run out of the ability to go higher by maxing out the knob on scope,by raising the rear of the scope you will be aiming higher to start with so you won’t have to adjust up as much
Upvote 0