FX IMPACT: Power Wheel setting

Forums PCP Airguns FX IMPACT: Power Wheel setting

  • Views : 1109
  • Link

    Ronin001
    Participant
    Member

    After discussing with Tom (tominco) about Impact settings  he asked if I could confirm that if the Impact in fact has different reading on the Impact Powerwheel settings.  So I figure to pass this along…. 

    SETTINGS:
    -Valve more or less set to the 4th line
    -Powerwheel spring set with no/to min slack
    -JSB 25cal 25.39 Pellets
    -shroud was not extended 

    Rotating clockwise Max 5, 4, 3, 2, 1, Min, 1, 2, 3, 4, 5  (Max 1a… Min 1b…)

    MAX
    953
    963
    964
    959 5a       942 5b
    960            950
    959            948
    951 4a       953 4b
    953            940
    948            946
    939 3a       940 3b
    945            940
    933            936
    930 2a       921 2b
    932            915
    938            924
    911 1a       900 1b
    914            888
    911            890

    MIN
    860
    849
    861

    AVERAGES
    MAX
    960 

    5A       5B
    959     946
    4A       4B
    950     946
    3A       3B
    939     938
    2A       2B
    933     920
    1A      1B
    912     892

    MIN
    856

    I would say yes there are indeed 12 setting on the Impact as Tom wanted confirmed and Ted has suggested/stated on one of his vids.  

    toms link http://airgunnation.dev/topic/does-the-impact-actually-have-12-power-settings-2/?view=all#post-49006
     

    Link

    APerfectMiss
    Participant
    Member

    Appreciate the clarity on this. Thanks for putting the time in to document and write this up.  

    Link

    Ronin001
    Participant
    Member

    My numbers are off a little compared to Tom or Michaels which may be to do Reg set to a slightly lower pressure.  

    Link

    sharroff
    Participant
    Member

    Ronin001,

    I wonder if the set screw that touches the underside of the adjuster wheel is set the same on all guns.  I’m guessing no.
     

    Link

    mreed1
    Participant
    Member

    Thank you!

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.