The metal valve seat need improvement, right VS on the right to compare ---- I just see too many break, fits most FX AG.
FX Impact heavy duty Aluminum / Bronze valve seat mod.
- Thread starter sniperlabyo
- Start date
Good idea! After watching one of your earlier videos...... I was wondering if you had something in mind. I broke one on a Royale.
Upvote 0
very informative Ernest. FX should use this on their updated Impact to reduce failure rate = to more happy airguners
Upvote 0
Ernest, is there any way you could put your email address on the forum or this post. I was wanting to get you to do some work on my Impact and need a way to get in touch with you.
Thanks
John
Thanks
John
Upvote 0
Hi Ernest
i had the same problem when i tuned the Impact to 130 Joules and also made a new one in stainless steel, which is also 1 mm wider and better o ring fitting and now no problem anymore.
alu bronce is also very strong material
good work
regards Cees
i had the same problem when i tuned the Impact to 130 Joules and also made a new one in stainless steel, which is also 1 mm wider and better o ring fitting and now no problem anymore.
alu bronce is also very strong material
good work
regards Cees
Upvote 0
Excellent solution Ernest.
It happen to me and replace it with the factory valve seat that I dont trust anymore.
Waiting for yours to replace.
It happen to me and replace it with the factory valve seat that I dont trust anymore.
Waiting for yours to replace.
Upvote 0
Nice to meet you Ernest.
Im in the waiting list and my .25 impact should be delivered within 1 or 2 weeks. I already have all the orings i Could need in case of an air leak and i would like to have one of your valves. Could you sell one to me please?
Im in the waiting list and my .25 impact should be delivered within 1 or 2 weeks. I already have all the orings i Could need in case of an air leak and i would like to have one of your valves. Could you sell one to me please?
Upvote 0
for all wanting to know the price, it's $50 with lifetime replacement and come with C3 replacement delrine bumper. the bore is 6mm, stock bore is 5.5mm. I can bore from 4.5 to 6.20mm by request. recommend 4.5mm for .177 and 6.20mm for max speed for .30 cal.
this HP VS can fit all FX AG That has a 9.90MM OD VS
this HP VS can fit all FX AG That has a 9.90MM OD VS
Upvote 0
6mm bore is fine for .30 cal shooting 44g around 865Fps,
on my mod .30 I'm shooting 44g around 920fps max but lowered to 880fps with 6mm bore VS
on my mod .30 I'm shooting 44g around 920fps max but lowered to 880fps with 6mm bore VS
Upvote 0
you will need a mod valvehousing and external 30cc air tube to go over 900fps
that extra 30cc tank vent directly 1/8" from the VS
that extra 30cc tank vent directly 1/8" from the VS
Upvote 0
