FX Impact fixed shroud disassembly ?

It looks like my Wildcat.25 but I couldn't remove it. Any ideas?

Glued, the end of shroud is threaded to a bushing and glued and that bushing is set screwed to the barrels 

Heat gun to the rescue!

http://www.fxairguns.com/wp-content/uploads/2017/04/Pipkitt-sprängskiss-Fixxed.pdf

GQ,

The FX pdf URL is dead.

Did anyone save that file ? if so, DM me.

thx,

Tim

If the parts are metal, then heat will work. I recently used heat to remove silencers from both of my HW100 rifles. If these parts are similar, it will take more heat than you might think. I used a propane torch, and had to get it hot. One warning, the amount of heat required might slightly discolor the metal finish. 

I got lucky and a little propane torch worked like ELH said but I dont think it discolored at all. Takes a fair amount of heat.

I did with a electric heat gun and clamp it in a vise. finally ended up turning an upgrade part on the lathe.

Regarding the shroud of a Impact M3 does someone know if is it threaded or glued? The same question but a different end of a shroud

Both ends of the tube are threaded, if that is what you asking.