Fx crown fitting a new power adjuster

Forums PCP Airguns Fx crown fitting a new power adjuster

  • Views : 778
  • Link

    wolfie
    Participant
    Member

    Hi

    A dealer can supply straight away a new Fx Crown .25 laminate. It has to be shipped though in 6 ft lbs format and comes with a power adjustment kit . This changes it to normal full power via adjuster etc.
    Is this easy to fit?

    safe shooting

    Link

    Menttaliist
    Participant
    Member

    Dead easy, if i’m not mistaking is the same as on the Royale’s block

    Link

    weatherby
    Participant
    Member

    “Menttaliist”Dead easy, if i’m not mistaking is the same as on the Royale’s block

    
Hey Manuel :)
    Although the priciple is the same, the Crown power adjuster is way bigger than the one from the Royale. (4.5mm vs 7mm inner diameter)

    Link

    wolfie
    Participant
    Member

    Hi guys

    to increase power from the 6ft lbs gun by using their extra cost supplied kit. Is it possible then to do thst by just a change of the power adapter as shown in the Royale video? Hard to believe an increase from 6 ft lbs to 45 ft lbs by just that part.
    Feedack welcome.

    safe shooting

    Link

    Menttaliist
    Participant
    Member

    “weatherby”

    “Menttaliist”Dead easy, if i’m not mistaking is the same as on the Royale’s block

    
Hey Manuel :)
    Although the priciple is the same, the Crown power adjuster is way bigger than the one from the Royale. (4.5mm vs 7mm inner diameter)

    That’s what i meant Gijs! The same principle not the power adjuster itself, but thanks :)

    Link

    Menttaliist
    Participant
    Member

    “wolfie”Hi guys
    to increase power from the 6ft lbs gun by using their extra cost supplied kit. Is it possible then to do thst by just a change of the power adapter as shown in the Royale video? Hard to believe an increase from 6 ft lbs to 45 ft lbs by just that part.
    Feedack welcome.
    safe shooting

    Are you sure that’s the only thing that that kit includes?

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.