We’ve been talking over in the FT forum about homemade targets. With some people snowed in, I figured if you have time, a welder and some scrap you could use this thread and run with it. Here is what I made and how I made it
Here are are the scraps of pipe and 3/8” steel I had laying around. Got them for free from a metal shop down the road.
Cut them up with a sawzall for mock-up.
then got out the tig welder and went to work - although a mig or stick would have been faster
I coped (ground with a bench grinder a semicircle into the metal to make it fit the pipe) the center target backer so it would be flush
Had to check alignment. Built up welds on either side of the pipe like a ramp to keep the targets in place while spinning. 
Made one one leg longer to make it easier to press into the ground. Ready for paint. 
Done
Here are are the scraps of pipe and 3/8” steel I had laying around. Got them for free from a metal shop down the road.
Cut them up with a sawzall for mock-up.
then got out the tig welder and went to work - although a mig or stick would have been faster
I coped (ground with a bench grinder a semicircle into the metal to make it fit the pipe) the center target backer so it would be flush
Done
