Can Crown's barrel be installed on Impact?

Forums PCP Airguns Can Crown's barrel be installed on Impact?

  • Views : 376
  • Link

    mubhaur
    Participant
    Member

    Did anyone try to install Crown's STX. 22 barrel on 1st and 2nd generation FX Impact ?

    Is it possible without machining?

    Regards 

    Link

    edosan
    Participant
    Member

    Without the shroud it might, not sure 

    Link

    Shinyknight
    Participant
    Member

    You can swap liners between the two. They use the same liners. Liners is the one that have the rifling. The barrel is actually just a hollow tube to hold the liner.

    Link

    elh0102
    Participant
    Member

    Shinyknight

    You can swap liners between the two. They use the same liners. Liners is the one that have the rifling. The barrel is actually just a hollow tube to hold the liner.

    Liner and sleeve, both inside the shroud.

    Link

    Glem.Chally
    Participant
    Member

    Would have a different barrel inlet as well.  But diameter of sleeve and barrel inlet should be identical.  Shroud is different as mentioned.

    Link

    AirSupply
    Participant
    Member

    Yes you can. I have a very early Impact and I have a Crown. I have 5 barrels. They all fit either my Impact or my Crown. Just need to change the shroud. 

    Link

    FearnLoading
    Participant
    Member

    Without the shroud the barrels are interchangeable. You Will need a spare moderator like a hugget or a Donny FL to screw on to either barrel since the original shrouds aren’t exchangeable. 

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.