Benjamin Handpump & Hatsan Flash?

Man, always ask first. I am sorry. I hate those pumps. Owned about 5 & rebuilt over 20x's I would have told you if no cash for a Hill MKII (don't bother with moisture trap gimmick, pump in dry room where a dehumidifier runss) than get a G6 best deal out there with 2 rebuild kits included & no reason to use anytime soon if you pump 50-60 strokes, let cool, bleed out, start over, keep lubed lightly. 

In 8 years of hand pumping, no rust in Discoveries. You must learn to disassemble pump, clean & lube piston every so rarely often. Ask, more knowledgeable guys than I will help also. The Flash is a good deal. 

are you pulling the handle up all the way and pushing it down all the way? 



short stroking the pump put any air in the gun.





as for the noise, on the upstroke it will suck in air to compress,so that may be the noise youre hearing.

Bad pump, check valve (s).

Rebuild or if you can RETURN. The G^ is a bit better and the taousa is better again and under $100.00.

I would personally try to return it for full credit if possible. NEVER liked the "benjamin" - not serviced by crosman- pump. LOW QC from the get go.

Best wishes in your endevors.





John

I had something similar happen with a new probe and adapter. Though it was tight enough for a good crush on the Delrin seal in the coupler but it wasn't and still leaked. I sucked up the fitting a bit more and it was fine.

I use a $40 ebay hand pump on my Flash and it works but I think I'm having a problem too. The handle goes up and down very easy but the last inch of the down stroke is extremely hard. I'm about 160lbs and I'm using ALL of my body weight for that last inch. But it does work and I'm able to refill my gun. This is my first PCP and high pressure pump so I thought it was normal but I've seen videos of people using hand pumps and they don't seem to work the way mine does.

Is this a common problem with cheap pumps? Or is it just how the cheap pump I got works? Maybe the Flash has some issue that is causing this?