Back Bag Rest for Bench

Is the small scissor jack fro Caldwell too?

Is it moving? How stable is it?

Great idea! thank you

Why didn't you post this a few weeks earlier? Looks like a great idea but I already did this https://www.airgunnation.com/topic/another-mod-for-the-fx-impact/ a few weeks back. Still I may get one anyway as it is not connected and can be used on anything.

I use one of these. I grabbed the cheapest (with a full width scissors thing) I could find on amazon. There are versions with 2/3 width scissor/lifters that are a couple buck cheaper. Works great when I have the room. Even my bullpups hang off the back the table I usually shoot from. That's my fault, I just don't always have the room to support the rear. I'll toss up a pic of the setup (if no one else does) but it won't be until tomorrow at best. Is it stable? Yes(ish) depends on expectations.... I certainly wouldn't lean my weight on the rifle and nothing will stop it from moving left/right if not locked down but it's usually more stable than just shouldering the gun with from a front bipod,

Great idea, I ordered the "wine red" aluminum one early today after reading this post, I like it... Seen the idea elsewhere too... No more 2x4 or blocks of wood under my Protektor bag...

Ken

Great idea! Thanks for posting. I just ordered a 4x4 Aluminum one rated for up to 10KG load and some non-slip 4x4 adhesive furniture pads that I think will be perfect to keep it from moving around on the bench and should help keep the bag from sliding around on the top of it as well.