amp reg question

Forums PCP Airguns amp reg question

  • Views : 283
  • Link

    Siscakidd
    Participant
    Member

    I am not one to tinker with the settings aside from the trigger just not needed for the type of shooting I do ,the factory settings have always been the way I run my guns and have not touched a regulator except on the impact,my question is how much turning on the adjustment screw do you make ?  The only info I could find is that you have to pull the trigger every 1/4 turn when adjusting,but no matter what I did could not get it shooting any faster then 780 fps,and it started dropping fps going in the same direction that was speeding it up,are the adjustments really tiny ….like a 1/4 turn is a huge swing. I am confused  is there another adjustment I should make. I thought the .30 wildcat was spose to be around 820fps out of the box

    Link

    T3PRanch
    Participant
    Member

    Probably a question that can be answered by a call to UAG. Few of these are in the wild yet!

    Link

    Glem.Chally
    Participant
    Member

    Is it a case of reg pressure going up, so if the hammer spring isnt raised too the speed would go down as the valve is harder to open with more back pressure?

    From the regulators i adjusted a little does alot.  1/4 turn is quite a bit.   But zero experience with this gun or this reg.

    Link

    Siscakidd
    Participant
    Member

    Ok…that makes sense,that’s what was happening started in the right direction and then when the other way

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.