All parts together for my .22 setup on impact

Forums PCP Airguns All parts together for my .22 setup on impact

  • Views : 397
  • Link

    Glem.Chally
    Participant
    Member

    Got the last bits last night for my 700mm .22 setup on impact.

    Elected to just get a slug liner from pba rather than pellet. Huge thanks to jimmy "jking" for relaying me parts.  I had backed off the little hammer spring adjusting screw all the way to make the power wheel have the full range.

    55fpe at 135 without breaking a sweat,  the slug liner chambers my mp molds 5.52 slugs with just finger pressure i think im gonna love it.  I have no doubt it would break 70fpe with more hst and higher reg pressure.  

    If you want a cheaper way to change calibers on impact or crown pm me.

    Link

    Bob_O
    Participant
    Member

    Very nice Glem!!

     

    🙂

    Link

    jking
    Participant
    Member

    A dollar here and a dollar there = more pellets, slugs and accessories. Good idea you had there Glem.

    jking

    Link

    Glem.Chally
    Participant
    Member

    Turned up the wick a bit to 160 Bar and did a bit of porting.  Still have the probe factory shape with the full circle but opened up the inside a bit.

    25.4gr Monster 1060fps

    33.95 Beast 961

    MP Molds 5.52mm slug 36.6gr at 941 for 72fpe,  its a hammer!

    Link

    hsnmz
    Participant
    Member

    Glem.Chally

    Turned up the wick a bit to 160 Bar and did a bit of porting.  Still have the probe factory shape with the full circle but opened up the inside a bit.

    25.4gr Monster 1060fps

    33.95 Beast 961

    MP Molds 5.52mm slug 36.6gr at 941 for 72fpe,  its a hammer!

    WOW that is a Thor's hammer. How is the shot noise?

    Link

    Glem.Chally
    Participant
    Member

    With heavier stuff not too bad,  its the light stuff that really snaps.

    This is at about 60fpe.  (No ldc/moderator)

    Link

    Airgun-hobbyist
    Participant
    Member

    That's not too loud.  My .30 with the moderator sounds the same @160.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.