Air Arms s510 Scope rings

on 44MM medium will work fine.

Havent looked through the scope you mention but believe I've read eye relief is no issue on that one?

I like these on the AA

http://www.bkltech.com/BKL-30mm-Offset-Dovetail-Rings-p/bkl-374.htm



John

With the S510 you will want high profile scope mounts as even with a 1" scope the medium height mounts do not provide sufficient clearance over the pellet magazine.

With the S510 you will want high profile scope mounts as even with a 1" scope the medium height mounts do not provide sufficient clearance over the pellet magazine.

Click to expand...

The AA US has an adjustable cheek piece anyway.

Personally, I would get med and high 30mm BKL’s to check magazine clearance, then return the pair that is no usable.

For the record, the AA S500 (single shot, no magazine) can accommodate a low 30mm BKL with a 6-24x50 scope attached to it without the objective bell touching the shroud—I have the very set-up myself.

Havent looked through the scope you mention but believe I've read eye relief is no issue on that one?

I like these on the AA

http://www.bkltech.com/BKL-30mm-Offset-Dovetail-Rings-p/bkl-374.htm



John

Click to expand...

If his UTG is the compact version, then he would surely need an offset set.

Great advice from everyone. The mag height on a s510 is a bit of a PITA. If you have a 30mm tube and ~50mm front objective you will most likely need medium rings.

You will take great advantage using offset rings as mentioned earlier.

If you don't use offset rings, your scope/rings contact points for proper eye relief wind up being stupid.

Get the offset rings.

Also, UTG make these for around $15 with dual screws for the 11mm and the 30mm scope mounts. Much better that a single screw affair IMHO....

Will

Even with my low 30mm BKL's I still had to install a SopMod GodAGrip sorbothane cheekpad on mine for proper alignment:











I got long arms and neck, lol!