Yong Heng after piston replacement

[bigHUN]

I have finished my basement during vaccine hysteria, and my YH workshop got out to my garage.
I made a dedicated 30A plug for it.
Also, running a continuous water in the bucket from a garden hose. No bs radiator upgrades or ice packs, but I can see my water separator dual towers pulling an impressive moisture from the ambient air.

 

[JimD]

My YH resides in a small room off my car garage. It has a dedicated spot in the corner. The breaker box is in the same room. I used the YH and it's water pump and fans all powered by one outlet in that room via a power strip with a 15A fuse. Worked fine for several years. But the YH was broken in by the time I set this up and I think that reduced it's peak demand. After I replaced the piston, the demand was higher and the YH alone was too much for the power strip breaker. So it is plugged into an outlet on a different circuit in the nearby car garage. It works for now. I can add another outlet closer to the YH and I will if it's demand doesn't drop soon. I'm not sure if that will take a few more bottle fills or several years of use. When I decide to mess with running the wire (opening up the wall is the bigger issue) is probably the main determining factor. If I decide to work on it I will test to be sure there is still a problem and if there is, I'll fix it.

I'm mainly pleased that it doesn't struggle to get the bottle to 300 bar now. I can deal with higher electric demand.