$1725 or a Brocock Ranger and an HW75/Beeman P2 for everything listed below.
Early Leshiy 2, .25 / 250mm. Shoots ragged 1 hole groups of JSB Exact King and NSA 36gr / .254 out to reasonable squirrel ranges. Kings currently at ~815 fps.
Gun as set up is as quiet as a short barrel L2 can get, as flexible for pack carry as possible, arguably as good of a small game woodswalker setup as can be imagined.
Extras included:
All the stock extra pucks, back plates.
350cc bottle from Edgun Spain.
Short top tube from Edgun spain. LOP at 14". Original top tube included.
Yankee Hill Machine bottom rail. This hugs the stock shroud avout 1mm off perfectly.
Striplin 1/2 UNF adapter. Already installed.
Behemoth 4 stack and QD adapter.
STO insert, already installed.
STO 250mm in long shroud insert.
Prototype STO action cover.
This was the gun STO used to develop their products
Gun has a ding on the edge of the aluminum faceplate of the butt stock. It does NOT effect the operation or integrity of the gun. The two shots from before I sanded the burr off did scratch the finish of one mag face plate, which still works perfectly.
Never had a leak. Gun has operated flawlessly in adverse conditions from -10 degrees hunting in the upper midwest to high summer in SETX.
Selling because it is too much thump to use in my back yard. Even at 815 fps Kings rip through an inch of duct seal and ring the back plate of my trap. I love this thing but I can't use it regularly in our small backyard.
Original box included, not pictured.
Zelle or personal check and wait to clear only. No Paypal.
Early Leshiy 2, .25 / 250mm. Shoots ragged 1 hole groups of JSB Exact King and NSA 36gr / .254 out to reasonable squirrel ranges. Kings currently at ~815 fps.
Gun as set up is as quiet as a short barrel L2 can get, as flexible for pack carry as possible, arguably as good of a small game woodswalker setup as can be imagined.
Extras included:
All the stock extra pucks, back plates.
350cc bottle from Edgun Spain.
Short top tube from Edgun spain. LOP at 14". Original top tube included.
Yankee Hill Machine bottom rail. This hugs the stock shroud avout 1mm off perfectly.
Striplin 1/2 UNF adapter. Already installed.
Behemoth 4 stack and QD adapter.
STO insert, already installed.
STO 250mm in long shroud insert.
Prototype STO action cover.
This was the gun STO used to develop their products
Gun has a ding on the edge of the aluminum faceplate of the butt stock. It does NOT effect the operation or integrity of the gun. The two shots from before I sanded the burr off did scratch the finish of one mag face plate, which still works perfectly.
Never had a leak. Gun has operated flawlessly in adverse conditions from -10 degrees hunting in the upper midwest to high summer in SETX.
Selling because it is too much thump to use in my back yard. Even at 815 fps Kings rip through an inch of duct seal and ring the back plate of my trap. I love this thing but I can't use it regularly in our small backyard.
Original box included, not pictured.
Zelle or personal check and wait to clear only. No Paypal.
Last edited: