Worlds biggest PCP "moderator" :-)

[far_shot]

You just know I'm going to get something a bit too loud someday.
I had a cardboard shipping tube laying to waste and a roll of 1" foam rubber. I put this together in about 15 minutes.
FX .30 report is indistinguishable as anything annoying...... just a muffled 'foop' and the pellet swishing apart the air down range. Sets up quickly and at 25X, I can see both the 100 and 123 yard targets and not see the "moderator" at all in the scope. Target impact is still very noticeable, but I doubt the natives be none the wiser.

 

[ptthere]

You got a tax stamp for that?

LOL, jk.

 

[shoot44]

.

 

[Gunnertrones]

Simple is better! Very innovative, and that goes for your restbench also.

 

[STO]

BRINGS UP AN INTERESTING QUESTION.

Since it is not attached to the rifle would you need a tax stamp even if was a firearm???

My understanding is that this is a legal gray area. If you make it small and rifle-close enough you could get in trouble. On the flip side of the coin, virtually all gun ranges do this to some extent on a larger scale for the sake of their neighbors. Where exactly the line is drawn and why is unclear. 

I could also be completely wrong, I'm just some dude on the internet after all. 

@OP Very clever. Love it. I bet that actually works amazingly well. 

 

[DirtyDovi]

Hahaha

Dude, you've got me beat! I give up! . . . For now..

*Looks for a bracket to mount a 55 gallon drum to a tripod* 

 

Sam -

 

[Gunnertrones]

DD, is this thing for REAL!

edit: ok, saw the thread on the PCP-section now. The thing is absolutely for real.

 

[Dpittman]

Does DonnyFl make an adapter for that

 

[GBGUNNER]

I believe donny makes an "extension" to fit the emperor

 

[kaylaindy]

Good job. 

 

[Acruz]

Does DonnyFl make an adapter for that

 

[DirtyDovi]

DD, is this thing for REAL!

edit: ok, saw the thread on the PCP-section now. The thing is absolutely for real.

Hahaha Yessir, that thing is most certain for real!
In all honesty, the whole thing started out as a joke. I had no clue Donny had those 'extenders'.. 
A member showed the setup in one of his threads, so, I joked about getting one to use on my 
Ronin and/or Emperor V3 - And then install them on the smallest guns that I had kicking around..
Well, no sooner did I photoshop a picture on here for a few laughs, I hopped on the classifieds, 
and a member had this extender for sale.. I'm all for laughs, so, impulse kicked in and I got it..
It definitely makes for an 'interesting setup' on the smaller rifles, and especially this pistol! lol
Eventually, I'll be using it on my .25 cal Kral Nemesis [to quiet it down for indoor use] 

 

Sam -

 

[DirtyDovi]

 
For everyone with a sense of humor, and a bit of imagination, 
There's this bad-boy also.. My custom DonnyFL DSLR camera lens adapter.. 
Now I can use my DonnyFL suppressors on my camera lenses, and with great results! 
Muffled auto focus micro motor noise, and, with the reduced diameter letting light through, 
I can get some really cool 'pin-hole-camera-photo-effects' also! Hahahaha

Alright . . . On that note . . . 
I can tell that it's time to try to get some sleep.

 

Sam -