need some help,when i pull the trigger on my wc i have to manually push trigger forward for it to cock...is the spring on the lever ,where adjustment screws are,what is suppose to return trigger to unfired position?
Mine had the same problem. The stock screw is too long and contacting the trigger linkage. Back off the screw and try it if it is ok then shorten the screw.
If one of the trigger adjusting screws is adjusted too far, it has this same symptom. I believe that it's actually the overtravel screw if I recall. It will allow the trigger to disengage for one shot, then won't reset.
Wendell, have you had the gun apart any? Maybe removed the barrel or air tube? If you don't get the barrel to air tube clamps set precisely back to where they were on the air tube/barrel then that will throw the whole cocking dimensions off not allowing sear to engage the hammer properly. It'll also change your velocity because now the pellet probes depth has also been altered. I went through this with my WK MK1 25 then realized what was going on. I now document a few measurement and mark the air tube with a pencil before disassembling the gun for any work. Hope this helps and solves your problem.