Wildcat regulator

[Yote]

I’m replacing my stock regulator with a huma .what I need to know is if the spacer that is on top of the stock reg. Goes back on the huma.For those that have replace .there’s what was the best setting found for 18 to 21 grain pellet At the moment I’m at average 850 fps

 

[cootertwo]

The Huma for my Wildcat came with it's own spacer. It is a little longer I've set mine to 150 bar, but still playing with different pellets and weights.

 

[Yote]

Thanks cootertwo that’s a starting point

 

[Groundhog]

For .22 wouldn't 120 bar be a better starting point ? My .25 is running at 143 bar stock . You can put a pressure gauge in place of the brass screw in the breech to check where the stock reg is running .

 

[BigTinBoat]

My .177 is set at 125bar and it will max out 10.34's in the 950's. Based on that I'd start at 130 with the .22

 

[cootertwo]

(150 bar) I was hoping to get some good velocities with the Monster 22 cal 25.3 gr

 

[Yote]

Cootetwo and how did it work out ?

 

[Crusher]

My Huma for my .177 came with its own ring. That ring is just slightly taller than the stock one. But what is important is to make sure the breather hole in the tube is lined up between to 2 o-rings on the reg. Mine is set to 120 and shoots the 10's at 905.

Crusher

 

[Yote]

Thanks crusher that’s good to know lm assuming that’s why the spacer is a little longer to line the breather hole up.

 

[N89]

Can’t wait for your results!

 

[gatorboots]

"N89"Can’t wait for your results!

I second this! Good luck with the mod and we will wait to hear the good news.

 

[Yote]

I guess it takes awhile when you order right from HuMa. Still waiting. In the mean time I drilled a hole right in line with the hammer spring adjust ment .may not look pretty but it’s gonna beat the hell out of removing the action from the stock .