Sorry, but I can't seem to find a good reference for how to adjust the probe alignment. On both my Maverick and Wildcat when the bolt is closed the probes are too far out of the transfer port. When out of the rifle, if I align the transfer holes in the pellet probe and transfer port, mark the probe, and reinstall, the probe is not fully aligned with the hole in transfer port. I need to get the probe to seat further into the transfer port. I've tried to move the connection point between the cocking lever and cocking rod by resetting the two set set screws that hold it in place. I can get the probe to align properly when closed, but I can't cock the rifle. It appears the hammer is not pulled back enough to engage the sear. The side mount (with the set screws) contacts.the rear barrel support before sear grabs. The cocking rod is threaded into the probe carrier and by turning the rod you can change the relative distance of the probe from the connection to the cocking lever, but still can't find a position where the probe is seated properly when closed and still cocks. I hope this is clear and there's a relative easy tuning solution that will enable a less restricted air path between the transfer port and the probe. Thanks.