Does anyone know the size of the O rings on the FX Wildcat fill probe ? It looks like they are urethane as opposed to buna or viton.
www.airgunnation.com
Harbor Freight has some variety packs you might get lucky with.
I learned early on from the community a few things when I got into PCP -Order extra o-rings from a place like https://www.theoringstore.com/store/ (a few of all of them) -Have a second fill probe also (they can get lost easy)
The number designations are all over the place. I believe it is a #47 danco oring. But I also think it is a 009 buna n oring as well. I believe they are the same size.
Isn’t it metric? Generally can’t use a dash size O-ring in place of a metric. For example the -0xx series is about ten thousandths larger than an M1.5 and ten thousandths smaller than an M2.
If the proper size is a M1.5, you can get the nearest fit -00x and abrade it down with a drill and Dremel. Can get you up and running same day when there’s no local source of metrics.
Thank you all for your comments, I visited 3 different hardware stores and finally found one that carried o rings small enough to consider. Sadly some of them were mixed up, but I matched a few to my one good ring I had removed from probe. I believe the size was 7/32 x 11/32. anyway they fit and probe works like new. Thanks again for pointing me in the right direction. Grump
You can also go to hatsan’s Website and order their 10 pack of fill probe o rings. The hatsan fill probe and fx wildcat fill probes can be used interchangeably