I have a Leapers/UTG one piece medium (18mm version) and it is good. Are there any out there that are lower? I need an offset mount and would like to keep the scope closer to the barrel.
Joe
Joe
Who makes medium or low offset 30mm tube picatinny rings or one piece mount?
- Thread starter JWilson
- Start date
so we can help at all you need to put a link of what you have
I could look for a long time and never really know, so you help us and maybe we can help you
I could look for a long time and never really know, so you help us and maybe we can help you
Upvote 0
I seen this one in another post and it appears to be very low, it looks a lil beefy and heavy...
The label on it says "spuhr"...
Ken
The label on it says "spuhr"...
Ken
Upvote 0
Not sure they would get any lower than what you already have:
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F132723574491
Upvote 0
Those are probably better but I just bought some off Ali Express for 7 bucks. They are holding zero just fine but are obviously not bkl level or anything.
Upvote 0
The Nightforce A190 seems to be about the lowest I have seen. Not cheap but I am sure would be very good. Looking to keep an NX8 snug to the R5M Matador. A 12” Long 2.5-20X50 seems pretty smoking. I simply have to try it out.
Joe
Joe
Upvote 0
They're quite low, I can vouch for that. I'm actually installing an A191 as I type this (slightly higher, 20MOA canted).
Upvote 0
This mount places the scope even lower. Now satisfied
Nightforce Mount came inThis mount places the scope even lower. Now satisfied
Looking good!
Upvote 0
Joe,
Do you know the height on the Nightforce scope mount if it's measured from the top of the picatinny rail to the center of the scope rings? This portion here?...
Do you know the height on the Nightforce scope mount if it's measured from the top of the picatinny rail to the center of the scope rings? This portion here?...
Upvote 0
The A190 is 1.125” The diopter is now 1mm lower than the top of my Knights Armament bubble level.
Upvote 0