I'm trying to remove an LDC from a shroud. The LDC unscrews but leaves its end cap with threads still on the shroud. I've tried gripping that end cap with a rubber pad used to remove stubborn lids from jars. No luck. This is not one of those epoxied permanent installs. I guess my finger tight twist was just a bit too much.
Any suggestions to get a better grip without marring anodized finish? I don't have a vise that I could line with rubber or leather.
Any suggestions to get a better grip without marring anodized finish? I don't have a vise that I could line with rubber or leather.