Went smooth, he makes a good kit, even called him with a quick question he was cool and explained to me what i needed to do. I will say, make sure your spring compressor works good, i ended up compressing by hand, not too bad as im am a big guy, but damn ill never do it that way again, i prefer the finesse route with things, smooth and accurate.
Lastly, the barrel was a bitch to align with the tube, i ended up putting an allen key in the other side and compressing the barrel back just enough to slide the bolt in, then everything went fine, and its shooting good, no twang or vibration, tho a solid kick my accuracy is much better now(chopped a few weeds down at 18 yards iron sights). Im guessing the barrel seal was causing the tiny gap.
Either way, the next time will go 1000% more smooth, its the same as building your first computer, a bit of a pain, but after a few youre an expert at assembly.
Lastly, the barrel was a bitch to align with the tube, i ended up putting an allen key in the other side and compressing the barrel back just enough to slide the bolt in, then everything went fine, and its shooting good, no twang or vibration, tho a solid kick my accuracy is much better now(chopped a few weeds down at 18 yards iron sights). Im guessing the barrel seal was causing the tiny gap.
Either way, the next time will go 1000% more smooth, its the same as building your first computer, a bit of a pain, but after a few youre an expert at assembly.