Wondering if the veyron 6-24 on the avengex will allow you to use the high capacity magazine? Because the scope is short I want to be sure there's room to slide the scope back in order for the taller mag to fit. Thanks
Veyron on avenge-x?
- Thread starter seanfrev
- Start date
That depends on your scope height, which is dictated by your scope ring height. Perhaps ask on the PCP category what ring height is needed for the large mag.
Upvote 0
Sean,
Can't help with Avenge-X or the high-capacity magazine but have five Vector Veyron 6-24x44s. Scope comes with 30mm Weaver Rings 1.2" High Profile. A diagram on the box shows the 1.2" is measured from lowest point (that fastens to Picatinny Rail) to mid-point where top and bottom ring halves come together. Also, other than my FX M3 and Wildcat MK3, I've had to use Marcool or WestHunter Cantilever 30mm scope rings for proper eye relief (pictured.) The super subcompact size just doesn't reach far enough back, even mounted at end on Picatinny rail. WM
Can't help with Avenge-X or the high-capacity magazine but have five Vector Veyron 6-24x44s. Scope comes with 30mm Weaver Rings 1.2" High Profile. A diagram on the box shows the 1.2" is measured from lowest point (that fastens to Picatinny Rail) to mid-point where top and bottom ring halves come together. Also, other than my FX M3 and Wildcat MK3, I've had to use Marcool or WestHunter Cantilever 30mm scope rings for proper eye relief (pictured.) The super subcompact size just doesn't reach far enough back, even mounted at end on Picatinny rail. WM
Upvote 0