Tuning Umarex Notos has arrived.

[MikeWazowski]

This is from Troy@Bigairprecision.

Hi Michael,
The Notos moderator inserts usually knock the sound down around 10dB or more. The insert replaces the oem baffles and is pinned in place. They are $50 for the moderator insert and 12-shot mag combo. I'm not selling them separately anymore.
Thanks!

 

[NCAirLine]

This is from Troy@Bigairprecision.

Hi Michael,
The Notos moderator inserts usually knock the sound down around 10dB or more. The insert replaces the oem baffles and is pinned in place. They are $50 for the moderator insert and 12-shot mag combo. I'm not selling them separately anymore.
Thanks! View attachment 540329

Thanks, Troy! I never did get around to posting a picture for Mike.

 

[MikeWazowski]

Ok for anyone interested I ended up putting the foam in the OEM red baffles. The results? Same noise level lol! (measured avg. Db with iPhone app)
I didn't really expect much anyway...

Fyi the knurled pins were facing knurled side down.

Here's some pics... I only did the front two baffles in order to leave some room for air expansion..

 

[MikeWazowski]

Also here's a homebrew bottle mod I made... There were some scrap metal bits lying around on a table, and my friend had this empty bottle. Right away this creation popped into my mind, and would you believe, it actually worked without having to tweak anything!

It's basically a foam-lined expansion chamber, that slides snugly over the stock shroud. It cuts the avg. Db level down by 10 which is not too shoddy if i can say so myself!


Looking down the "barrel"

The rear end

In it's full glory

Anyways after all this fun, I plan on going with the subscriber 3d design as a more practical solution.

 

[MikeWazowski]

For punching out the pins, it was really easy with a nail that had it's point flattened, as suggested by someone on this forum.

 

[MikeWazowski]

Hi does anyone have tips/suggestions to be aware of before adjusting the trigger to make it lighter?

1) I have zero experience fooling around with triggers so I'd rather safer than not
2) I'm not interested in disassembling the gun

Thanks in advance!

 

[Sicumj]

There is a set screw in the trigger that you can remove and round the point off some. Helps with trigger pull.

 

[MikeWazowski]

There was someone on the forum complaining about a lack of storage space in the Notos. Not sure it was this thread, but I'm assuming this is a good spot for this. All I did was ziptie this Lucas "Muecas" candy container snugly to the stock. Just snip off the lollipop stick that's in the cap. It fits 2 mags, and if you do it right, the single shot tray as well. It really stays in place, and all you do to access mags is pop off the orange cap. (The candy comes in other colors if you're picky, but mango and watermelon are the best ones!). Still working on the coloring... Also working on gluing a tiny metal piece inside the cap to stick the single shot tray there.

P.S. For anyone who removed the thin piece connecting the bottom of the grip to the stock, it makes no difference as the container cannot move in that direction as it flares a bit towards the cap end.