Apparently my SL 25 came with no grub screws. I'm looking for "2" of these screws. The barrel is loose!
Umarex Umarex Guantlet SL 25 barrel grub screws
- Thread starter Powerstroke
- Start date
those are the barrel grub screws in the receiver block, the other 2 holes are for Picatinny rail installation, tighten to about 10-15 inch pounds
BTW, you need to replace the O-ring seal on the Barrel as it is damaged.
BTW, you need to replace the O-ring seal on the Barrel as it is damaged.
Upvote 0
OK, I'll look again. All I see is 2 empty holes and threads, I think? Plus a damaged Oring!
Upvote 0
Yes, both are missing. When I tried to remove the barrel shroud, both and the barrel and the shroud popped off.
Upvote 0
I will pull a set screw from my 1st generation Umarex Gauntlet if the screws are likely to be the same. I can measure the screw, thread pitch and length.
Will that help?
Will that help?
Upvote 0
What about these screws. They look like grub screws. They also look like they match up with the flat spots on the barrel ? As someone else mentioned your o ring on the barrel looks damaged as well.
Upvote 0
Yes sir, someone else noticed the damaged Oring. I ordered a full set of Orings from Captain Oring.
Last edited:
Upvote 0
Still looking for grub screws.
still haven't heard from these guys:'
I've contacted Umarex, Hajimoto and thammer(AGN) Waiting to hear from anyone?
still haven't heard from these guys:'
I've contacted Umarex, Hajimoto and thammer(AGN) Waiting to hear from anyone?
Upvote 0
I bought an assortment of metric grub screws off Amazon. Sizes m3 to m8 Every time I needed one it was in the kit. About 10 bucks
Upvote 0
I know. Those look like the set screws to me. Probably a 5mm Allen wrench ? The small holes missing set screws dont look like through holes.
Upvote 0
I figured out the issue and I'd rather not say! I will blame my "Strokes" Aphasia.....
Everything good now!
Sorry for being such a PAIN!!!
Everything good now!
Sorry for being such a PAIN!!!
Upvote 0