Ran good for 12.3 hours at 10 to 15 minuets at a time .That is 2 months for me topping off tank. Now blows its breaker within a min or two after pressuring up. Any thoughts would be swell ! Thanks
TXEDO11 Circuit breaker
- Thread starter UDABEGGER
- Start date
Well it vibrates while running like I suppose they all do . I will see if I can get a new breaker . Cheap place to start ! Thanks
Upvote 0
12.3 hours in 2 months? What's the run time for topping off 1 tank & from what pressure TO what pressure? 12.3 hours is an awful lot of run time.
My YH tops off my 60 minute tank from 3500-4300psi in 7 to 9 minutes so I'm curious about yours.
My YH tops off my 60 minute tank from 3500-4300psi in 7 to 9 minutes so I'm curious about yours.
Upvote 0
clean your check valves. Make sure water is not sneaking in to hi pressure side. Probably a bad seal, and water is building up in hiprssure cylinder
Upvote 0
They arc and leave lots of carbon deposits on the contact which just makes them trip more and deposit more carbon. If you replace your old one open it
.
Last edited:
Upvote 0
Solved ! Tuxing advised me to clean the valve plate on high pressure cylinder head .The job was easy and now runs fine. 
Upvote 0