Is the barrel length the same between the standard MK3 and the HC ver? Anyone with chrono data? Thanks.
So then there should be no MV difference if same spring is used between the 2 models? Assuming all other variables are held constant.
These are the variables I am suggesting to hold constant. If so the muzzle velocity will be the same on all 3 models?
You're not reading it correctly TBH, I asked them if ALL 3 barrel lengths were the same. I clipped things down to be quick. The full question I asked was were ALL 3 barrel lengths the same (TX & HC & PS) The response was as noted above, "The technical department has advised that yes it is the same".
I wanted to post this with my reply above. Here is one of my TX200 “rifle” barrels. Breech to muzzle on internal barrel is 13”+
I’ve also had both PS and HC barrel assemblies apart, but can’t seem to locate my pictures. But the barrels on both of them are identical at about 9.5” from breech to muzzle of barrel only. Some of the info posted on the specs online have been incorrect.
Steve
![]()