So there i was cleaning some spray paint overspray off of my compressor with a little trusty brake cleaner........ I was thinkin dang this thing works pretty good.... Sprayed a little bit on the unit instead of on the towel and found out those 4 pole single throw switches from china hate brake cleaner because the switch melted seized and broke when i tried to turn it on. I cant see myself filling anything up with my backup hand pump so could somebody provide a wire diagram or even better a pic of the main switch for a tuxing compressor i have the new switch but am not smart enough to figure out on my own. I own the one with the pressure switch that still needs a bucket of water the exact one pictured here. Thank you all soo much in advance. 
Tuxing main switcher dealy
- Thread starter chapawolfe
- Start date
Mark the terminals A-B-C Tag the wires with the same A-B-C as you remove them and install on the New Contactor that has been marked the same as the old one.
Upvote 0
I have had good success reaching out to TUXING for many questions and parts. You might try contacting the vendor you purchased from or the TUXING Official Store on Aliexpress.com. Either should be able to explain how the broken switch is wired (by colored wires) into your compressor.
Upvote 0
I thought about marking them and all that before i took them apart... however removal of the switch housing turned out to be much more involved probably cuz of the destruction caused by the solvent. Ok thanks everybody ill reach out to tuxing and or the Brain. I am very appreciative of all the help.
Upvote 0