Thread size on Crosman/Benjamin HP Hand Pump?

[sdeeter19555]

I need to make the Crosman hand pump slightly more compact for storage in a hard case. Easiest way to do that looks like installing a 90 degree elbow between the base and the flexible hose.

The crimped hose fitting they use is about two inches long, turning it to the side would give me the clearance I need.

It appears to be metric?

Before I go down this path of trying to determine that thread size, anyone already did this?

 

[Camaro454]

Crossman will give you this info. if you contact them. My pump has a female M10X1 thread in the block but it is not a Crossman.

 

[sdeeter19555]

I actually took the fitting and hose off the base (which was fun because they use something like gray RTV as a sealant), it's a standard 1/8" NPT male with a metric "nut".

Had a 1/8" high pressure tee in the garage, just need to put it back together.