Seneca/Sam Yang Seneca Dragonfly MK 2
- Thread starter Powerstroke
- Start date
Working now! The middle linkage near the end of the barrel needed a lot of oil!!! Working now, just pumped to 15 pumps and shot a C.P. 14.3gr. at 701fps.
Thanks everybody!!!
Thanks everybody!!!
Upvote 0
Ya, i dont know about that either.. unless took apart to wipe off clean and dry to fresh lube assemble.
Id be concerned the alcohol would not mix eell with any oils in there snd gum up to make a bigger mess issue .
If you got the exploded view diagram maybe just take it apart clean inspect and good fresh proper lube ? Pretty much where your at .
I don't even see a fix kit on ebay ..
Upvote 0
I have not fired my Dragonfly in probably in over 2 years, just been shooting my PCP’s.
It seems it loss some power, I’ll check my notes?
It seems it loss some power, I’ll check my notes?
Upvote 0
Well hell! Last night I pumped her with 5 pumps@@500fps+, then 10 pumps@600fps+ then 15 pumps@701fps. Went to bed. This morning....nothing!?!
No pressure at all???
No pressure at all???
Upvote 0
Id call it scared seal .. the oil temporarily fills any clearance bit not " pumping" to keep it "applied" it ozzes away and the clearance gaps are back ( opinion)
You rember a old bike tire hand pump would stop pumping unless you oiled it and next time you use it it was not pumping again untill you oiled it again . Especially the leather seal ones . You grabbed that old can of non detergent 30w quaker state motor oil and drip it in on the seal and your back to pumping good ..lol
Upvote 0
***FLASH***
Working again! I didn't do anything...lol
Just shot about 100 pellets, it's easy to pump but I'm worn out. Getting to old I guess.
Working again! I didn't do anything...lol
Just shot about 100 pellets, it's easy to pump but I'm worn out. Getting to old I guess.
Upvote 0
Another day and still working. I oiled this so much that everytime I pump, it spits oil all over me. A few chrony numbers:
Ave. numbers...
C.P.H.P 14.3-660fps @ 10 pumps.
FX 15.89-645fps @ 10 pumps.
C.P.H.P.14.3-715fps @ 15 pumps.
FX 15.89-683fps @ 15 pumps.
Ave. numbers...
C.P.H.P 14.3-660fps @ 10 pumps.
FX 15.89-645fps @ 10 pumps.
C.P.H.P.14.3-715fps @ 15 pumps.
FX 15.89-683fps @ 15 pumps.
Last edited:
Upvote 0
"The Dragonfly pump head is a neat assembly of o-rings and an open-foam wiper to hold and distribute the oil. This is how it looked as it came from the box."
I got to wonder if you can go get orings and replace them make the whiper out of leather or maybe its somthing common foam stuff to find to cut a new one ?
From...
I got to wonder if you can go get orings and replace them make the whiper out of leather or maybe its somthing common foam stuff to find to cut a new one ?
From...
The Seneca Dragonfly multi-pump pneumatic rifle: Part 1 | Blog | Pyramyd AIR
by Tom Gaylord Writing as B.B. Pelletier Air Venturi Seneca Dragonfly multi-pump air rifle. This report covers: Information Irony First impressions Sights Lubrication Shot it immediately Trigger Reader’s comment How hard to pump? Nostalgic Summary There are always things at the SHOT Show that I...
www.pyramydair.com
Upvote 0
No idea, still have not heard from Air Venturi, numerous emails and nothing."The Dragonfly pump head is a neat assembly of o-rings and an open-foam wiper to hold and distribute the oil. This is how it looked as it came from the box."
I got to wonder if you can go get orings and replace them make the whiper out of leather or maybe its somthing common foam stuff to find to cut a new one ?
From...
The Seneca Dragonfly multi-pump pneumatic rifle: Part 1 | Blog | Pyramyd AIR
by Tom Gaylord Writing as B.B. Pelletier Air Venturi Seneca Dragonfly multi-pump air rifle. This report covers: Information Irony First impressions Sights Lubrication Shot it immediately Trigger Reader’s comment How hard to pump? Nostalgic Summary There are always things at the SHOT Show that I...www.pyramydair.com
Upvote 0
I contacted CaptainOring and they do not stock the kit but they are sure they have the needed Orings, just need to measure them.
Upvote 0
I have an extra Dragonfly rebuild kit. The forarm broke on mine and I'd be happy to semd you the kit I have. If you'd PM me, I'll send it right along. Orv.
Upvote 0