Seneca Aspen/Nova Freedom parts list

[cegd]

I just rebuilt my aspen .25, replaced almost every single oring/seal. 80% sure i assembled everything correctly per the assembly guide, however when I try to fill up the gun with the fill probe from an air tank, the air comes straight out the barrel end and the aspens pressure guage does not budge at all. I have rebuilt the rifle a few tile in the past and never had this issue.

Any feedback or suggestions would be much apreciated.

 

[SilentSquirrel]

@cegd
It is most likely the firing valve. (air release valve)
It is shown, but not numbered, on page 11 of the instructions
Just to the right of Part 9 are the valve and valve spring
Check with Pyramyd Air or Air Venturi, they might still stock them
IIRC the valve used in the original Avenger is an upgraded version of that part

Hope this helps
Edward

 

[cegd]

@cegd
It is most likely the firing valve. (air release valve)
It is shown, but not numbered, on page 11 of the instructions
Just to the right of Part 9 are the valve and valve spring
Check with Pyramyd Air or Air Venturi, they might still stock them
IIRC the valve used in the original Avenger is an upgraded version of that part

Hope this helps
Edward

Thanks again for your prompt reply. Yes I noticed the firing valve is not numbered on the assembly manual. I'll try to ask around for the part. I wonder if it is possible to restore it by changing the "rubber" like material on it that acts as the seal.

 

[SilentSquirrel]

Thanks again for your prompt reply. Yes I noticed the firing valve is not numbered on the assembly manual. I'll try to ask around for the part. I wonder if it is possible to restore it by changing the "rubber" like material on it that acts as the seal.

The Avenger uses the same valve. (Not sure about Avenger X)
You might find one at Pyramyd AIr or Air Venturi

 

[Murfdurf82]

If anyone needs some piston seals, let me know and I can sell them. I went ahead and ordered a bunch of them...they are supposedly the best ones for this apllication and can stand up to high heat- high pressure, much better than the stock seal on the piston. My seals should be here next week . I have paypal and can ship them out very inexpensively, in a small envelope.. I would suggest buying at least 2 seals. These are the high grade Polyurethane Oring, -006 90A Durometer . They come in a pack of 25 for around $20 { with shipping fees- taxes} but most people arent gonna want to spend $20 for a pack of 25 because they will never use 25 seals.

Hi do you still have any seals for sale or a way to get the sizes?

 

[SilentSquirrel]

Hi do you still have any seals for sale or a way to get the sizes?

@Murfdurf82

They can be had at The O-Ring Store

Hope this helps
Edward

AS568-006 UC90 Cast Urethane O-Rings 90 Duro Disogrin 9251 TODI [UC90006] : The O-Ring Store LLC, We make getting O-Rings easy!

The O-Ring Store LLC AS568-006 UC90 Cast Urethane O-Rings 90 Duro Disogrin 9251 TODI [UC90006] - UC90 Cast Polyurethane O-Rings – 90 Duro – Disogrin® 9251 TODI by Freudenberg Designed for heavy-duty applications, The O-Ring Store LLC’s UC90 Cast Polyurethane O-Rings are crafted from...

www.theoringstore.com