SEKHMET Digital Gauge Problem

[mike8908]

My digital pressure gauge on my FX impact is now showing 0 bar it’s full and fully charged can anyone tell me how to fix it???

 

[Glem.Chally]

Try leaving it alone for 5-10 mins then try again. I had this happen a couple times when changing bottles.

 

[mike8908]

The one for the bottle is fine but this one is on the power plenum.

 

[Glem.Chally]

Did you just install it? Or it's been on for a while?

 

[mike8908]

Yeah I’ve had it for like 3 months.

 

[Glem.Chally]

If it was mine I'd swap them around and see what happens.

 

[mike8908]

It’s still showing the same.

 

[mike8908]

It’s showing 50 bar with no bottle but 0 bar with a bottle...

 

[triggertreat]

At this point I believe I would contact Sekhmet for assistance or pull the battery for a hard reset.

sekhmet digital gauge - Bing images

sekhmet digital gauge - Bing images

 

[mike8908]

How do you take it apart?

 

[triggertreat]

How do you take it apart?

• Email: [email protected]

 

[stoti]

Do not take it apart! They are not meant to ever be taken apart.

There are reset instructions on the Sekhmet website. 

Stoti

 

[mike8908]

Can you link it? I can’t find that.

 

[triggertreat]

Can you link it? I can’t find that.

Clink on the link I provided to you. I figured there maybe a reset, but didn't find it quick enough in my quick search.

Here is the SEKHMET video on how to clear the data: https://www.youtube.com/watch?v=kFQqROLDwOM&t=1s

SEKHMET +1 626-501-4602

 

[dannya1a]

I had the same issue when I just installed mine a few hours ago on my power plenum as well. I ended up loosening the gauge till it registered plenum pressure the turned it a slight bit more to get the orientation I wanted. Then plugged in for a full charge up. Thus far mine is running good. I am currently seeing a 1 bar creep in my plenum pressure. I’ll see what it really can get to as it sits till tomorrow.

 

[fe7565]

Clearing the data does not reset the device. You can reinstall the firmware...which should reset it. 

 

[cosmic]

You need to short the two left contacts (upper and lower left ) with a paper clip or something conductive

 

[tuneafish]

So it apears that Sekhmet is sending out gauges that have bad software and will not show airgun pressure.Good luck with getting the new or actually old software that works downloaded onto your gauge.I asked the help of a more computer saavy friend than myself to get this done and we could not get the software to open on the computer so downloading it to the gauge was impossible.Very Frustrating waste of time.